Dtmf Memory Encoder; Programming A Dtmf Tone Sequence - Icom ID-E880 Instruction Manual

11

DTMF MEMORY ENCODER

Programming a DTMF tone sequence

DTMF tone sequences are used for autopatching, accessing
repeaters, controlling other equipment, etc. The transceiver
has 16 DTMF memory channels (d0–d9, dA, dB, dC, dD, dE,
dF) for storage of often-used DTMF tone sequences of up to
24 digits.
q Push and hold [DTMF](MONI) for 1 sec. to enter the DTMF
set screen.
w Rotate [DIAL] to select
e Rotate [DIAL] to select the desired memory channel, then
push [ ](MONI).
• Previously programmed DTMF code is displayed if pro-
grammed.
[EXAMPLE]: Programming "5428AB453" into DTMF memory channel "d4."
[MENU ] [DIAL] [DTMF]
[ ] [ ]
142
DTMF-M, then push [ ](MONI).
" "
Push and hold [DTMF] for 1 sec.
[ ]
Rotate [DIAL] to select the desired code, then push [ ].
r Rotate [DIAL] to select the desired code.
t Push [ ](LOW) to select the next digit.
• Pushing [ ](CS) moves the cursor backward.
y Repeat steps r and t until the desired DTMF tone se-
quence is input, then push
• Up to 24 digit can be programmed.
u Push [ ](MONI) to program the DTMF tone sequence and
exit the programming mode.
i Push [MENU
Rotate [DIAL] to select "DTMF-M," then push [ ].
Enter DTMF memory.
Repeat the previous step until the desired
tone sequence is entered.
(MONI).
[ ]
] to exit the DTMF set screen.
Rotate [DIAL] to select "d4,"
then push [ ].
Push [ ], then push [MENU ].