Scan Edges Programming - Icom ID-E880 Instruction Manual

Scan edges programming

Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 0A/0B to 24A/24B, in memory channels.
q Push [VFO/MHz] to select the VFO mode.
w Set the desired frequency:
Select the desired band with [BAND].
Set the desired frequency with [DIAL].
Program different frequencies in "
spectively.
Set other data
(e.g. frequency offset, duplex direction, tone
, if desired.
squelch, etc.)
e Push [S.MW](MW) to enter the select memory write mode.
• " " indication and memory channel number blink.
[EXAMPLE]: Programming 145.300 MHz into scan edges 4A.
[ DIAL ]
VFO mode
[S.MW ]
A" and " B" re-
Push [S.MW].
Enter select memory write mode.
r Rotate [DIAL] to select the desired programmed scan
edge channel from 0A to 24A.
t Push and hold [MW](S.MW) for 1 sec.
.
• 3 beeps sound
• The other scan edge channel "B," 0B to 24B, is automatically
selected when continuing to push [MW](S.MW) after program-
ming.
y To program a frequency for the other pair of scan edges,
0B to 24B, repeat steps w and t.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
Rotate [DIAL] to select scan edge channel 4A.
Push and hold [MW] for 1 sec. to program
Return to the VFO mode.
SCAN OPERATION
Channel 4A
8
8
103