Table of Contents
Advertisement
4
DV MODE PROGRAMMING
Gateway repeater call sign programming (GW CAL)
i Push [ ](MONI) to enter the gateway repeater call sign
programming state. See p. 40 for gateway repeater call
sign programming details.
• Gateway repeater call sign programming screen is displayed.
• Programmed repeater call sign is displayed and the 8th digit is
automatically added or replaced to "G."
o When the programmed repeater has gateway capability,
push [ ](MONI) to exit gateway repeater setting and skip
to !2 . Or when the programmed repeater has a different re-
peater for gateway communication, follow the next step !0 .
• When the repeater does not have a gateway repeater, follow the
next step !0 , too.
!0 Program the other gateway repeater call sign, then push
[ ](MONI) to exit the state.
• Rotate [DIAL] to select the desired character, number, symbol
('/'only) or space.
• Push [ ](LOW)/[ ](CS) to move the cursor right or left, respec-
tively.
• Call sign can be up to 8 digits long, but 8th digit must be set to
"G."
• When the repeater does not have a gateway repeater, but has
several linked repeaters, in the same zone, assign a common
name to all repeaters. (up to 7 digits). In this case, you must set
the 8th digit to " " (blank).
!1 Rotate [DIAL] to select the next content (repeater group
programming).
36
Repeater group programming (GROUP)
The ID-E880 has a total of 10 groups (0–9). You can assign
and organize up to 300 repeater lists in the 10 groups. Group
selection is helpful for quick recall of the desired repeater.
!2 Push [ ](MONI) to enter the repeater group programming
state.
• Repeater group programming screen is displayed.
• Selected group number appears and group indicator blinks.
!3 Rotate [DIAL] to select the desired repeater group.
• Selected group number appears and group indicator blinks.
!4 Push [ ](MONI) to set the repeater group and exit the
state.
!5 Rotate [DIAL] to select the next content (access repeater
setting).
Advertisement
Table of Contents
