Table of Contents
Advertisement
Access repeater setting (R1 USE)
The programmed repeater lists are assigned to use or not
to use the access repeater (RPT1) in the DR mode. To use
for RPT1, repeater frequency, duplex direction and frequency
offset must be programmed.
!6 Push [ ](MONI) to enter the access repeater program-
ming state.
• Access repeater programming screen is displayed.
!7 Rotate [DIAL] to select "YES" or "NO."
• When "NO" is selected, the repeater cannot be selected as the
access repeater (RPT1) in the DR mode.
• When "YES" is selected, the repeater can be selected as the
access repeater (RPT1) in the DR mode.
!8 Push [ ](MONI) to exit the state.
When "NO" is selected at step !7 , skip to step #1 .
When "YES" is selected at step !7 , rotate [DIAL] to
select the access repeater (RPT1) programming.
Follow the next step !9 to program the repeater.
DV MODE PROGRAMMING
Frequency programming (FREQ)
This content appears when R1 USE is selected YES.
!9 Push [ ](MONI) to enter the frequency programming
state.
• Frequency programming screen is displayed.
@0 Rotate [DIAL] to select the frequency band.
• The selected number blinks at 1st digit.
• Push [ ](LOW) to move the cursor right; push [ ](CS) to move
the cursor left.
• Push and hold [CLR](DR) for 1 sec. to clear the displayed fre-
quency.
@1 Repeat step @0 until the repeater frequency is set.
@2 Push [ ](MONI) to set the frequency and exit the state.
@3 Rotate [DIAL] to select the next content (duplex direction
programming).
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
37
Advertisement
Table of Contents
