Programming Memory Channels - Icom ID-E880 Instruction Manual

QUICK REFERENCE GUIDE

Programming memory channels

The ID-E880 has a total of 1052 memory channels
25 pairs scan edges and 2 call channels)
operating frequency, repeater settings, etc.
1. Setting a frequency
In the VFO mode, set the desired operating frequency with
repeater, tone and tuning steps, etc.
Push [VFO/MHz] to select the VFO.
Rotate [DIAL] to set the desired frequency.
• Set other data, such as repeater tone, duplex information, tuning
step), if desired.
2. Selecting a memory channel
Push [S.MW], then rotate [DIAL] to select the desired mem-
ory channel.
• "X" indicator and memory channel number blink.
[S.MW ] [DIAL]
3. Writing a memory channel
Push and hold [MW](S.MW) for 1 sec. to program.
• 3 beeps sound.
• Return to the VFO mode automatically after programming.
• Memory channel number automatically increases when continuing
to push [MW](S.MW) after programming.
XI
(including
for storing often-used
Using the HM-133
q Push [MR/CALL] to select the memory mode.
w Push [
C(T-OFF)] first, then enter the desired memory
ENT
channel via the keypad.
e Push [VFO/LOCK] to select the VFO mode, then set the
desired operating frequency, including offset direction, tone
settings, etc.
Push [VFO/LOCK] to select the VFO.
Push [ C(T-OFF)] first, then enter the desired operat-
ENT
ing frequency via the keypad.
• Set other data, such as repeater tone, duplex information,
tuning step, if necessary.
r Push [FUNC] then push and hold [
program.
Push , then
• 3 beeps sound.
• Memory channel number automatically increases when continu-
ing to push [ A(MW)] after programming.
CLR
A(MW)] for 1 sec. to
CLR