Table of Contents
Advertisement
D Reverse tone/DTCS squelch
The reverse tone/DTCS squelch is convenient if you want to
ignore a specific signal.
q Set the desired operating frequency and the desired oper-
ating mode.
w Set the desired CTCSS tone or DTCS code.
e Push and hold [TONE](M/CALL) for 1 sec. to enter the
tone selection state, then push [TONE](M/CALL) again.
r Rotate [DIAL] to select the desired squelch system.
Tone squelch reverse
t When a signal with unmatched tone or code is received,
the transceiver's mute is released and the received audio
sounds.
The transceiver mutes the squelch when a signal with the
matched tone or code is received.
D Setting tone squelch frequency
q Enter "C TONE" in the DUP.T menu.
w Rotate [DIAL] to select and set the desired CTCSS tone
DTCS reverse
frequency, then push [ ](MONI).
• Each operating band and each memory channel have indepen-
• See the table on page 148 for available tone frequencies.
e Push [MENU
TONE SQUELCH AND POCKET BEEP
MENU
DUP.T
C TONE (p. 121)
(Push [MENU
]), (rotate [DIAL], then push [ ](MONI).)
[MENU
]
[DIAL]
[
]
dent settings.
] to exit the DUP.T menu screen.
z Enter "C TONE" in DUP.T menu.
SET
MENU
DUP.T
B
(Push [
B(D-OFF)] to enter MENU screen),
SET
(Push [Y] or [Z], then push [
x Push [Y] or [Z] to select the desired tone fre-
quency, then push [
c Push [
A(MW)] to exit the DUP.T menu
CLR
screen.
12
C TONE (p. 121)
B(D-OFF)].)
SET
B(D-OFF)].
SET
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
147
Advertisement
Table of Contents
