Table of Contents
Advertisement
D One-touch reply using the call record
The stored call signs in the call record can be used to call the
other station.
q After receiving a call, push and hold [RX CS](CS) for
1 sec.
The received call sign is displayed
while pushing and holding
[CS]
• Set your own call sign (MY) in advance. (pgs. 30, 42, 43)
• The call sign in "CALLER" is stored as "UR," "RXRPT1" is stored
as "R2" and "RXRPT2" is stored as "R1."
• Error beeps sound when a call sign is received incorrectly, and
no call sign is set in this case.
w Push [PTT] to transmit; release to receive.
• Selecting a call record via RX CAL screen
q Select the desired record channel in steps q and w on
the previous page.
w Push and hold [MW](S.MW) for 1 sec. to copy the record
channel to current call sign.
e Push [PTT] to transmit; release to receive.
Important!
Setting call signs with the "One-touch reply using the call
record" operation as at left are for temporary operation
only. Therefore, the set call signs will be over-written when
another call record is used to set call signs.
• Never saved into a call sign memory.
CS
.
If you want to save the set call signs, see "Copying the call
record contents into call sign memory"
CS
For your information
When a call specifying your call sign is received, the call
signs of the calling station and the repeater it is using can be
automatically used for operation.
• When "CALL W (RX call sign auto write)"
"AUTO," the station call sign in "CALLER" is set to "UR" au-
tomatically.
• When "RPT W (Repeater call sign auto write)"
to "AUTO," the repeater call sign in "RXRPT1" is stored as
"R2" and "RXRPT2" is stored as "R1" automatically.
NOTE: The One-touch reply function can be used on the
same network system, but it cannot be used over different
network systems.
DV MODE OPERATION
for details.
(p. 47)
is set to
(p. 135)
(p. 135)
5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
is set
15
16
17
18
19
45
Advertisement
Table of Contents
