Memory Bank Scan - Icom ID-E880 Instruction Manual

8
SCAN OPERATION

Memory bank scan

IMPORTANT: To perform memory bank scan, 2 or more
bank channels MUST be programmed, otherwise the scan
will not start.
q Select memory bank mode.
Select the memory mode with [M/CALL].
Enter the bank selection state with [BAND].
Set the desired bank (A to Z) with [DIAL], then push
[BAND].
w Set the squelch level.
e Push and hold [SCAN](VFO/MHz) for 1 sec. to enter the
scanning type selection.
[DIAL] [SCAN]
All bank scan
Bank link scan
106
Push and hold [SCAN] for
1 sec.,then rotate [DIAL].
Bank scan
Selectable from "A" to "Z"
if programmed.
Duplex scan
r Rotate [DIAL] to select the desired scanning type.
• "ALL" for all bank scan; "B-LINK" for bank link scan or "BANK-
x
for bank scan ( = A to Z; programmed bank groups are only
displayed.), "DUP" (appears only when duplex operation is set)
for duplex scan, "TONE" (appears only when the subaudible tone,
tone squelch or DTCS squelch is set) for tone scan.
t Push [SCAN](VFO/MHz) to start the scan.
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction. This also
causes the transceiver to resume scanning.
• Push [SCAN](VFO/MHz) to stop the scan.
During all bank/bank link scan
The bank-link setting can be changed in SCAN set mode.
See page 124 for details.
Duplex scan function: Repeatedly scans two frequencies
(transmission/reception) during duplex scan operation.
Memory bank scan skips any memory channels in the se-
lected bank that are set to "SKIP" or "PSKIP."
Memory bank scan stops at the first channel when all
channels in a bank are set to "SKIP" or "PSKIP."
x
"
During bank scan