Icom ID-E880 Instruction Manual page 125

D Scan start/stop via the microphone
z Push [VFO/LOCK] to select the VFO mode for
SCAN
full/band/programmed scan; push [MR/CALL] to
2
select the memory mode for memory scan.
• Push [FUNC] + [
to select a bank for memory bank scan. Push
[ A(MW)].
CLR
x Push [
2(T-SCAN)].
SCAN
c Push [Y]/[Z] to select the desired scanning
type.
• For full/band/programmed scan
"ALL" for full scan; "BAND" for band scan, "P-LINK x
(or program scan link name if programmed)" for pro-
grammed link scan (x= 0 to 9), "PROGxx (or scan
name if programmed)" for programmed scan (xx= 0
to 24; only programmed scan edge numbers are dis-
played), "DUP" (appears only when duplex operation
is set) for duplex scan, "TONE" (appears only when the
subaudible tone, tone squelch or DTCS squelch is set)
for tone scan.
• For memory scan
"ALL" for all memory scan; "BAND" for band memory
scan, "MODE" for mode scan, "DUP" (appears only
when duplex operation is set) for duplex scan, "TONE"
(appears only when the subaudible tone, tone squelch or
DTCS squelch is set) for tone scan.
1(BANK)] then push [Y]/[Z]
MONI
SCAN OPERATION
• For memory bank scan
SCAN
"ALL" for all bank scan; "B-LINK" for bank link scan
2
x
or "BANK- " for bank scan (
bank groups are only displayed.), "DUP" (appears only
when duplex operation is set) for duplex scan, "TONE"
(appears only when the subaudible tone, tone squelch or
DTCS squelch is set) for tone scan.
v Push [
2(T-SCAN)] again to start the scan.
SCAN
b To stop the scan push [
[ A(MW)].
CLR
• Push [Y]/[Z] also stops the scan.
z Push [VFO/LOCK] to select the VFO mode for full
YZ
scan; push [MR/CALL] to select the memory
mode for memory scan.
• Push [FUNC] + [
MONI
to select a bank for memory bank scan. Push
[ A(MW)].
CLR
x Push and hold [Y]/[Z] to start the scan.
c Push [Y]/[Z] to stop the the scan.
8
x
= A to Z; programmed
2(T-SCAN)] or
SCAN
1(BANK)] then push [Y]/[Z]
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
107