Table of Contents
Advertisement
D Programming a memory channel via the microphone
The microphone can also be used to program mem-
MW
ory channels.
z Set the desired frequency in the VFO mode.
Push [VFO/LOCK] to select the VFO mode.
Push [
C(T-OFF)], then set the frequency using the
ENT
keypad.
Set other data (e.g. frequency offset, duplex direction,
tone squelch, current call signs, etc.), if desired.
x Push [MR/CALL] to enter the memory mode.
c Push [
C(T-OFF)], then set the desired memory chan-
ENT
nel using the keypad.
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel).
Push
,
Push
v Push [VFO/LOCK] to select the VFO mode.
b Push [FUNC] then push and hold [
to program.
3 beeps may sound and the VFO contents
subaudible tone frequency, etc.)
Memory channel number increases when continuing to
push [
CLR
Push
MR/
then
CALL
Push
then
for 1 sec. and continue to push
MEMORY/CALL CHANNELS
A(MW)] for 1 sec.
CLR
are programmed.
A(MW)] after programming.
Push
7
1
2
3
4
5
(including the
6
7
8
9
10
11
12
13
14
15
16
17
18
19
91
Advertisement
Table of Contents
