Memory Channel Programming - Icom ID-E880 Instruction Manual

7
MEMORY/CALL CHANNELS

Memory channel programming

q Push [VFO/MHz] to select the VFO mode.
w Set the desired frequency:
Select the desired band with [BAND].
Set the desired frequency with [DIAL].
Set other data (e.g. frequency offset, duplex direction,
tone squelch, current call signs, etc.), if desired.
e Push [S.MW] to enter the select memory write mode.
• "X" indicator and the memory channel number blink.
r Rotate [DIAL] to select the desired channel.
• Call channels (C0, C1), VFO and scan edge channels (0A/0B
to 24A/24B), as well as regular memory channels, can be pro-
grammed in this way.
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel).
[ DIAL ]
[S.MW ]
90
Push [S.MW].
VFO mode Enter select memory write mode.
t Push and hold [MW](S.MW) for 1 sec. to program.
• 3 beeps sound.
• Memory channel number automatically increases when continu-
ing to push [MW](S.MW) after programming.
NOTE: Push [MENU ] to cancel to program and exit the
select memory write mode before memory programming is
finished.
FOR YOUR CONVENIENCE
Memory programming can be performed in various ways e.g.
memory channel to the different memory channel, memory
channel to the call channel, etc.
Rotate [DIAL] to select channel 20.
Push and hold [MW] for 1 sec. to program
Return to the VFO mode.
Channel 20