Table of Contents
Advertisement
Erasing/transferring bank contents
The bank contents of programmed memory channels can be
cleared or reassigned to another memory bank.
INFORMATION: Even if the memory bank contents are
cleared, the memory channel contents still remain
programmed.
q Select the desired bank contents to be transferred or
erased from the bank.
(p. 93)
Push [M/CALL] several times to select the memory
mode.
Push [BAND], then rotate [DIAL] to select the desired
memory bank group, then push [BAND] again.
Rotate [DIAL] to select the bank channel.
• Bank initial and bank channel stops blinking.
[DIAL] [BAND]
[S.MW
]
[M/CALL]
w Push [S.MW] to enter the select memory write mode.
• Displays the original memory channel number automatically, and
then "X" indicator and the memory channel number blink.
• Do not hold [S.MW](MW) for more than 1 sec., otherwise the
memory contents will be copied to the VFO.
MEMORY CHANNEL OPERATION
e Push [
](MONI) to select "BANK" setting, then push [
(MONI) again.
r Push [ ](LOW) to select the bank channels selection, or
push [ ](CS) to select the bank group selection to be trans-
ferred.
t Rotate [DIAL] to select the desired bank group or channel.
• Push [CLR](DR) or select "– – – –" indication when erasing the
contents from the bank.
[ ] [ ][
]
[DIAL]
[S.MW
]
[CLR]
y After editing, push [
](MONI) to select "BANK" setting.
u Push [MW](S.MW) for 1 sec. to erase/transfer the bank
contents.
7
]
To transfer the bank contents
to channel 11 in Bank B.
Bank channel is displayed.
To erase.
"– – – –" is displayed.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
99
Advertisement
Table of Contents
