Extreme Networks Ridgeline Guide Manual page 222

Tuning and Debugging Ridgeline
Figure 167: Defining the scope of an alarm
You can scope an alarm to Device Groups and Port Groups as well as individual devices and ports.
To change the alarm scope for an existing alarm:
1 Open Alarm Manager, and click the Alarm Definition tab.
2 Select the alarm you want to scope, and click Modify.
3 Select the Scope tab
4 Uncheck the Scope on all devices and ports checkbox. This enables the Source Type and Select
Group fields.
5 The Source Types you can select are Device, Device Group, Port, and Port Group.
If you select either Device Group or Port Group, the area below (labeled Devices in the example)
will display a list of all the Device Groups or Port Groups defined in Ridgeline. When you select one
or more of these, it puts the group(s) as a whole into the Selection list at the right.
If you select Device or Port, then the Select Group field lets you select a Device Group to display the
devices in the group in the field below.
If the Source Type is Devices, individual devices in the selected Device Group can be added to
●
the selection list
If the Source Type is Ports, individual port ifindex values can be added to the selection list.
●
220
Ridgeline Concepts and Solutions Guide