Extreme Networks Ridgeline Guide Manual page 207

Figure 155: New Policy Rule Dialog - Match Conditions
5 Enter the Rule Name, Rule description, Rule category.
6 Click on the available conditions to view a description of each condition at the bottom of the dialog
box.
7 You can select a condition from the list of Available match conditions, then move each condition to
the Selected match conditions list on the right.
NOTE
All the conditions must be matched. That is, an implicit AND is included between all the match
conditions
The IP protocol field at the bottom of the dialog describes the choices in the Selected match
conditions. The following describes the conditions shown in the lists:
The blue icons before each condition indicate the OSI layer on which these reside.
●
Conditions that are not compatible with those you choose or not available are grayed out.
●
8 Click Next. The dialog opens and asks: What are the inputs for the selected match conditions for
your rule? See Figure
Ridgeline Concepts and Solutions Guide
156.
14
205