Extreme Networks Ridgeline Guide Manual page 371

To use the configFreeRadius command, do the following:
1 Open a command line console
Ridgeline installed location >
cd <
Figure 297: Command Line
2 At the next prompt, enter the following commands as described in
Table 19: ConfigFreeRadius Command Options
Command
configFreeRadius
configFreeRadius –p 10559
configFreeRadius –i 10.255.255.1,10.255.255.2
Ridgeline Concepts and Solutions Guide
(Figure 297) and enter:
Function
Set the FreeRADIUS server to listen requests from to all
the IP addresses that is on the server.
Set the port that the FreeRADIUS server uses, by default
the port is set to 10559. At the same time, it will set the
server to listen requests from to all the IP addresses that
is on the server as well.
Set the FreeRADIUS server to listen requests from one or
more IP addresses which is separate by a comma.
Warning: any all the IP must be valid; any invalid IP can
result in the server failing to start.
Table 19:
369