Modifying An Eaps Domain - Extreme Networks Ridgeline Guide Manual

Modifying an EAPS Domain

For existing EAPS domains, you can edit settings and deploy the changes to the devices where the
EAPS domain is configured.
To modify an EAPS domain, do the following:
1 Under Network Views, select the folder containing the EAPS domain you want to configure.
2 In the Navigation Table, click the EAPS tab, and select the EAPS domain you want to modify.
3 Right-click in the Navigation Table and select the setting you want to modify from the pop-up
menu.
For an EAPS domain, you can edit the device used as the master node, and the ports used as
primary and secondary ports, as well as the settings for the Hello and Fail timers.
4 If you select Properties from the pop-up menu, the Properties window for the EAPS domain is
displayed, which provides a list of settings you can modify.
Figure 138: EAPS Domain Properties Window
5 Click the setting you want to modify to bring up the provisioning box for that setting. For example,
Figure 139 shows the provisioning box for the EAPS Master node and port settings.
Figure 139: Provisioning Window for EAPS Master Node and Port
6 Make any necessary changes to the EAPS configuration, then click the Save changes button to
validate and deploy the changes.
Ridgeline Concepts and Solutions Guide
12
179