RIGOL
Waveform Analysis
This function is used to analyze the recorded waveform. Press UTIL Record
Mode and use
point, the screen is divided into two display areas as shown in the figure below.
Settings and Results
Please set the related parameters of waveform analysis by referring to the following
explanations.
1.
Analysis
Press Analyze to select the desired analysis mode.
Trace: Perform analysis on the basis of the templet selected by users. For
detailed introduction, refer to Analysis Based on Trace
Pass/Fail: perform analysis on the basis of the Pass/Fail mask created by
users. For detailed introduction, refer to Analysis Based on Pass/Fail
Mask.
2.
Source
Press Source to select the channel (CH1-CH4) to be analyzed. Note that only
channels currently enabled can be selected.
10-6
to select "Analyze" to open the waveform analysis menu. At this
Templet Display Current Frame
10 Waveform Recording
DS6000 User's Guide