Channel Label - Rigol DS6000 Series User Manual

RIGOL
2 To Set the Vertical System

Channel Label

You can modify the labels used to mark the analog channels (CH1 to CH4) at the left
side of the screen. The label is the number of the channel (e.g. ) by default and
the length of the modified label can not exceed 4 characters.
Press CH1 Label to enter the label modification interface. As shown in the figure
below:
Name Input Area Keyboard Upper-lower Case Switch
For example, change " " to " ".
Press Keyboard to select the "Keyboard" area. Select "Aa" using
and press
a
down to switch it to " A". Select "C" using and press down to input the
character. Use the same method to input "hn1".
To modify or delete the inputed character, press Name to select the "Name Input
Area" and use to select the character to be modified or deleted. Reenter the
desired character or press Delete to delete the selected character.
After finishing the input, press OK to finish the modification and the channel label
will change to " ".
DS6000 User's Guide
2-10