Auto Mode - Rigol DS6000 Series User Manual

RIGOL
6 To Make Measurements

Auto Mode

In this mode, one or more cursors will appear. You can use auto cursor measurement
to measure anyone of the 24 waveform parameters. Before using this mode, you
need to at least turn on one auto measurement parameter and the number of
cursors will change with the measurement parameters.
Press CURS  Mode  "Auto" and the cursors (the number of cursors correspond
to the measurement parameter which is turned on firstly) will be displayed on the
screen (different measurement parameters need different number of cursors). Note
that no cursor will be displayed if no auto cursor measurement parameter is selected
or there is no input of the measurement source. When the waveform is expanded or
compressed horizontally, the cursor will move accordingly.
If multiple measurement parameters are turned on later, you can use Meas.Para. to
switch among at most five measurement parameters that are turned on last and the
measurement parameter currently selected is high-lighted at the bottom of the
screen.
The following figure shows the example of auto measurement of the delay between
two channels.
DS6000 User's Guide
6-34