11 Waveform Record
Waveform Analysis
This function is used to analyze the recorded waveform. Press Record Mode and
use
to select "Analyze" to open the waveform analysis menu. At this point, the
screen is divided into two display areas as shown in the figure below.
Settings and Results
Please refer to the following explanations to set the waveform analysis parameters.
1. Analyze
Press Analyze to select the desired analysis mode.
Trace: perform analysis on the basis of the template selected by users. For
detailed information, refer to
Pass/Fail: perform analysis on the basis of the Pass/Fail mask created by
users. For detailed information, refer to
Mask".
2. Source
Press Source to select the channel (CH1-CH4) to be analyzed. Note that only
channels currently enabled can be selected.
MSO4000/DS4000 User's Guide
Templet Display Current Frame
"Analysis Based on
Trace".
"Analysis Based on Pass/Fail
RIGOL
11-7