Remote Interface Configuration; Lan Setting; Network Status - Rigol DS6000 Series User Manual

RIGOL

Remote Interface Configuration

DS6000 can communicate with PC via LAN, USB and GPIB (together with the USB to
GPIB interface copnverter of RIGOL) buses. Please refer to the introduction below
to configure the corresponding interface before using the remote interfaces.

LAN Setting

Press UTIL  IO Setting  LAN Set to open the LAN setting interface. You can
view the network connection status and configure the network parameters.

Network Status

Current IP
Config Type
MAC Address
VISA Address
IP Config Type
Status
Network Status
Connect the oscilloscope to your local area network using the network cable. The
network hole of the oscilloscope is at the rear panel. The oscilloscope will give
different prompts according to the current network connection status.
Net Config Success!

Acquire IP...

IP Conflict!

Unconnected!

DHCP Fail!

Read Status Fail!

13-2
13 System Function Setting
DS6000 User's Guide