Edge Trigger - Rigol DS6000 Series User Manual

RIGOL

Edge Trigger

Trigger on the trigger threshold of the specified edge of the input signal.
Trigger Type:
Press Type to select "Edge". At this point, the trigger setting information as shown in
the figure below is displayed at the upper right corner of the screen.
Source Selection:
Press Source to select CH1-CH4, EXT, EXT/5 or AC Line as the Trigger Source. The
current trigger source is displayed at the upper right corner of the screen.
Note: select channel with signal input as trigger source to obtain stable trigger.
Edge Type:
Press Slope to select to trigger on which kind of edge of the input signal. The current
edge type is displayed at the upper right corner of the screen.
: trigger on the rising edge of the input signal when the voltage level meets

the preset Trigger Level.
: trigger on the falling edge of the input signal when the voltage level meets

the preset Trigger Level.
: trigger on the rising and falling edges of the input signal when the

voltage level meets the preset Trigger Level.
Trigger Mode:
Press Sweep to select the Trigger Mode (page 5-3) under this trigger type as auto,
normal or single. The corresponding status light of the current trigger mode turns on.
Trigger Setting:
Press Setting to set the trigger parameters (trigger coupling and trigger holdoff)
under this trigger type.
Trigger Level:
Use TRIGGER
trigger mark " " appear on the screen and move up and down with the turning of
the knob, while at the same time, the trigger level value (e.g.
the lower left corner of the screen also changes accordingly. When stopping turning
the knob, the trigger level line and the trigger mark disappear in about 2 seconds.
5-8
LEVEL to modify the level. An orange trigger level line and the
5 To Trigger the Oscilloscope
DS6000 User's Guide
) at