Waveform Playback - Rigol DS6000 Series User Manual

RIGOL

Waveform Playback

Waveform playback can play back the waveforms currently recorded. Press UTIL 
Record  Mode and use
shown in the figure below is displayed at the upper right corner of the screen,
indicating the specific frame currently displayed on the screen. During the playback,
this value would change continuously.
Please refer to the following descriptions to set the playback parameters.
1. Play Mode
Press this softkey to set the playback mode to cycle or single.
: cycle playback. Play from the start frame to the end frame and then

repeat until you stop it manually.
: single playback. Play from the start frame to the end frame and

then stop.
2. Interval
Press this softkey and use
availbale is from 100 ns to 10 s and the default is 100 ns.
3. Start Frame
Press this softkey and use
is 1 and the maximum is the maximum number of frames recorded.
4. Current Frame
Press this softkey and use
to set the current frame. By default, the current frame is the same with the end
frame. The setting range of current frame is related to the start frame and end
frame settings. During the setting, the screen will display the corresponding
waveform of the current frame synchronously, namely manual playback.
If you perform the playback operation after setting this parameter, this menu will
be adjusted to the value corresponding to the "Start Frame" and will change
continuously during the playback process.
10-4
to select "Play back". At this point, the information as
to set the time interval of the playback. The range
to set the start frame of the playbak. The default
or the Navigation knob (large scale adjustment)
10 Waveform Recording
DS6000 User's Guide