Rigol DS6000 Series User Manual page 175

7 Protocol Decoding
5. Threshold
Refer to the introduction in Parallel Decoding.
6. Display-related Setting
Press Format and set the bus display format to Hex, Decimal, Binary or ASCII.
Press Offset and use
Press BusStatus to enable or disable bus display.
7. Decoding Table
The decoding table displays the decoded data, the corresponding line number,
time, frame ID, DLC, CRC and ACK information in table format.
Press Event Table  Event Table to select "ON" (note that this operation is
only available when BusStatus is set to "ON") to enter the decoding table
interface as shown in the figure below. If a USB storage device is currently
connected to the instrument, users can export the data table to the external USB
storage device in CSV format.
8. Interpreting Decoded CAN Data
Frame ID: displayed in hex digits in blue.

Data Length code (DLC): displayed in chartreuse patch.

Data Frame: displayed in green patches and in red patches if data frame is

lost.
Cyclic Redundancy Check (CRC): displayed in blue-green patch when valid

and red error mark is displayed when error occurs.
DS6000 User's Guide
to adjust the vertical display position of the bus.
RIGOL
7-17