Requirements For Outputting Audit Log Data - Hitachi XP P9500 User Manual

#1
The severity levels are as follows:
3: Error, 4: Warning, 6: Informational
#2
If you use Ctrl + C to cancel the DLMgetras utility for collecting HDLM
error information, audit log data indicating that the DLMgetras utility has
terminated will not be output.

Requirements for Outputting Audit Log Data

HDLM can output audit log data when all of the following conditions are
satisfied:
• The syslog daemon is active.
• The output of audit log data has been enabled by using the HDLM
command's set operation.
However, audit log data might still be output regardless of the above
conditions if, for example, an HDLM utility is executed from external media.
#:
The following audit log data is output:
¢
¢
¢
Notes:
¢
¢
2-40
Category Explanation
Categories: StartStop, Authentication, and ConfigurationAccess
Severity: 6 (Critical, Error, Warning, or Informational)
Destination: syslog (facility value: user)
You might need to perform operations such as changing the log size
and backing up and saving collected log data, because the amount of
audit log data might be quite large.
If the severity specified by the HDLM command's set operation differs
from the severity specified by the configuration file /etc/
syslog.conf, the higher severity level is used for outputting audit log
data.
HDLM Functions
Hitachi Dynamic Link Manager User Guide (for Linux(R))
Severity
Audit event
Processing of the
dlmupdatesysini
t command was
successful.
Processing of the
dlmupdatesysini
t command
failed.
Message ID
#1
6 KAPL15058-I
3 KAPL15059-E
#