Overview Of The Procedure For Installing Hdlm In A Boot Disk Environment; Boot Disk; Settings For Using An Hdlm Device As A Boot Disk - Hitachi XP P9500 User Manual

Overview of the Procedure for Installing HDLM in a Boot Disk
Environment
This subsection provides an overview of the procedure for installing HDLM in
a boot disk environment.

Settings for Using an HDLM Device as a Boot Disk

1 Check whether LABEL is used. If it is, remove it.
.
To use HDLM, you must remove the LABEL setting, because a SCSI device
cannot be identified from the value set in LABEL in an HDLM environment.
See steps 1 to 16 in
page
2 Install HDLM.
.
See step 17 in
3-106.
3 Edit the configuration file to change the definition such that the HDLM
.
device can be used as a boot disk.
After editing the configuration file, restart the host to activate the setting.
See steps 18 to 34 in
on page
After completing the above procedure, you can perform a new installation of
HDLM in a boot disk environment that uses a SCSI device.
Upgrade Installation in an Environment Where an HDLM Device Is Used as a

Boot Disk

To perform an upgrade installation of HDLM in a boot disk environment that
uses a SCSI device (for details, see
Where an HDLM Device Is Used as a Boot Disk on page
1 Edit the configuration file to change the definition so that the OS will start
.
with a SCSI device specified.
In the definition before the change, the OS starts with HDLM specified.
See steps 1 to 16 in
HDLM Device Is Used as a Boot Disk on page
2 Perform an upgrade installation of HDLM.
.
See step 17 in
Device Is Used as a Boot Disk on page
3 Change the definition such that the HDLM device can be used as a boot
.
disk.
Restore the configuration file to its state before the upgrade installation
was performed. See steps 18 to 32 in
Environment Where an HDLM Device Is Used as a Boot Disk on page
3-116.
After completing the above procedure, you can perform an upgrade
installation of HDLM in a boot disk environment that uses a SCSI device.
3-104
Settings for Using an HDLM Device as a Boot Disk on
3-106.
Settings for Using an HDLM Device as a Boot Disk on page
Settings for Using an HDLM Device as a Boot Disk
3-106.
Upgrade Installation in an Environment Where an
Upgrade Installation in an Environment Where an HDLM
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
Upgrade Installation in an Environment
3-116):
3-116.
3-116.
Upgrade Installation in an