Hitachi XP P9500 User Manual page 568

Message ID
KAPL12326-E
8-108
Message Text
The command could not
execute. Command name =
aa...aa
Messages
Hitachi Dynamic Link Manager User Guide (for Linux(R))
Explanation
Details
aa...aa: The failed command
Action
Perform the following confirmation
corresponding to the output
command, and then retry.
Re-execute the dlmmkinitrd utility
for supporting the boot disk after
performing the next check according
to the outputted command.
And if the error message is outputted
before this message, remove the
cause of the error with reference to
the contents of the message.
cp:
Confirm that there is enough unused
capacity and that the user has write
permission in the root directory (/).
cpio or dd:
Confirm that there is enough unused
capacity and that the user has write
permission in the /etc/opt/
DynamicLinkManager directory.
dlmcfgmgr:
Confirm that the version of the
¢
OS has not changed since you
made the initial ramdisk image
file.
Take action according to the
¢
contents output in the log of the
dlmcfgmgr utility.
Confirm that the user has write
¢
permission in the root directory
(/).
dlnkmgr:
Confirm that HDLM has been
¢
configured.
Take action according to the
¢
contents output in the log of the
dlmcfgmgr utility.
Confirm that the user has write
¢
permission in the root directory
(/).
gzip:
Confirm that that the unused capacity
is sufficient at the creation
destination of the initial ramdisk
image file.
mke2fs or touch: