Hitachi XP P9500 User Manual page 183

Change the initrd specification in the configuration that you copied in
step 23.
If you are using a Xen kernel, change the initrd file name specified in
module to the initial RAM disk image file you created in step 19. For
details on Xen kernels, see
Environments Supported by HDLM on page
Keep in mind that the specification method for initrd differs depending
on the boot loader.
If any options have been specified to suit the user environment, take care
not to delete those options.
27 If SUSE LINUX Enterprise Server 10 or SUSE LINUX Enterprise Server 11
.
is used, delete the resume setting contained in the boot loader
configuration file.
Delete the resume specification contained in the configuration that you
copied in step 23. If resume is set for the kernel parameter, delete the
resume setting, because it is not supported by HDLM.
28 In the boot loader configuration file, edit the settings to be used during a
.
boot.
When GRUB is the boot loader
¢
Change the default number so that a boot can be performed using
the configuration copied in step 23.
default= 3
When LILO or ELILO is used as the boot loader:
¢
Specify label for default.
default linux-HDLM
29 If LILO is used as the boot loader, execute the /sbin/lilo command to
.
have the new settings take effect.
30 Shut down the host.
.
Execute the following command to shut down the host:
# shutdown -h now
31 Change the configuration from a single-path configuration to a multi-path
.
configuration.
32 Start the host.
.
33 Execute the mount command to check that the HDLM device is mounted.
.
The following shows an execution example for when GRUB is used as the
boot loader:
# mount
/dev/sddlmaa2 on / type ext2 (rw)
:
:
/dev/sddlmaa1 on /boot type ext2 (rw)
/dev/sddlmaa4 on /tmp type ext2 (rw)
/dev/sddlmaa5 on /var type ext2 (rw)
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
Table 3-47 Xen Hypervisor Operating
3-67.
3-115