Preparations For An Upgrade Installation Or Re-Installation Of Hdlm - Hitachi XP P9500 User Manual

For details on setting the cluster software, see
page
RHCM on page
20 Execute the dlnkmgr command's view operation to check the HDLM
.
settings and status of each program.
The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size (KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Reservation Status
Intermittent Error Monitor : off
HDLM Manager
Alive
HDLM Alert Driver
Alive
HDLM Driver
Alive
License Type
Permanent
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd
#
Even when cluster software is being used, Support Cluster is blank.
However, the cluster function is operating normally.
21 Check that the correct version of HDLM is installed.
.
If HDLM version x.x.x-xx is displayed, the installed HDLM version is
correct. x.x.x-xx is the version of the installed HDLM.
22 Check that the programs are running properly.
.
If HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive, all
programs are running correctly.
If the programs are not running properly, see
Error on page
After the installation, check the path configuration according to the procedure
indicated in

Preparations for an Upgrade Installation or Re-installation of HDLM

This section describes the preparations required before performing an
upgrade installation or re-installation of HDLM.
3-84
3-178, Settings for Oracle RAC on page
3-181, or
Ver
x.x.x-xx
Ver
x.x.x-xx
Ver
x.x.x-xx
Expiration
-
5-6, and then take actions.
Checking the Path Configuration on page
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
Settings for VCS on page
: x.x.x-xx
:
: on(extended lio)
:
: 3
: 9900
: 2
: 0
: 1000
: 4
: on(30)
: on(1)
:
WakeupTime
yyyy/mm/dd hh:mm:ss
WakeupTime
yyyy/mm/dd hh:mm:ss
WakeupTime
yyyy/mm/dd hh:mm:ss
Settings for Heartbeat on
3-178, Settings for the
3-183.
ElogMem Size
What To Do for a Program
3-183.
1000