connected to the HBA port that has the specified host port number and
bus number.
Specify the host port number and bus number of the target HBA port: the
numbers are found in the PathName field displayed using the view
operation. Enter a period between these two parameter values. For
details about the view operation, see
6-28.
Example
The following example shows how to place online all paths connected
to an HBA port whose host port number is 0010 and bus number is
0000:
When the confirmation message is displayed, the user enters y to
continue, or n to cancel the operation.
# /opt/DynamicLinkManager/bin/dlnkmgr online -hba 0010.0000
KAPL01057-I All the paths which pass the specified HBA will
be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 3 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
#
-cha -pathid AutoPATH_ID
Use this parameter to place online, at one time, all the paths that pass
through a specific CHA port. The command will place online all the paths
that pass through the CHA port to which the path with the specified
AutoPATH_ID is connected.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see
(Displays Information) on page
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you
want to add a new LU without restarting the host, AutoPATH_IDs are re-
assigned to each path of the LU when you execute the HDLM-
configuration definition utility (dlmcfgmgr). Always make sure that you
use the view operation to find the current AutoPATH_ID of the target
path, before executing the online operation.
Example
The following example shows how to place online the paths connected
to the CHA port 0A. In this example, a path whose AutoPATH_ID is
000002 is connected to the target CHA port:
When the confirmation message is displayed, the user enters y to
continue, or n to cancel the operation.
# /opt/DynamicLinkManager/bin/dlnkmgr online -cha -pathid
000002
KAPL01057-I All the paths which pass the specified CHA port
Hitachi Dynamic Link Manager User Guide (for Linux(R))
view (Displays Information) on page
6-28. Leading zeros can be omitted
Command Reference
view
6-11