Hitachi XP P9500 User Manual page 185

When LILO is used as the boot loader:
¢
Root directory (/), /tmp, /usr, /var, swap
The following shows an example of the /etc/fstab file:
/dev/sddlmaa2
/dev/sddlmaa4
3 Execute the HDLM-configuration definition utility (dlmcfgmgr) with the -v
.
parameter specified to check the correspondence between the HDLM
device and the SCSI device.
# dlmcfgmgr -v
HDevName Management
/dev/sddlmaa configured
KAPL10302-I /sbin/dlmcfgmgr completed normally.
The HDevName column indicates the HDLM device, and the Device column
indicates SCSI device.
4 Edit the /etc/fstab file.
.
Change the mount points for the HDLM management-target devices that
you checked in step 2 from the HDLM device to the SCSI device.
Comment out the existing HDLM device specification by placing a hash
mark (#) at the beginning of each line, and then add the SCSI device
specification as shown below, based on the correspondence between the
SCSI device and the HDLM device as checked in step 3.
#/dev/sddlmaa2
/dev/sda2
#/dev/sddlmaa4
/dev/sda4
5 Copy the configuration contained in the boot loader configuration file,
.
which was used for startup from the HDLM device.
The following shows an example configuration. Note that option in the
example represents an option that can be specified to suit the user
environment.
When GRUB is used as the boot loader with Xen kernels:
¢
For details on Xen kernels, see
Environments Supported by HDLM on page
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
:
:
/ ext2 defaults
:
:
/tmp ext2 defaults
:
:
Device
/dev/sda
:
:
/ ext2 defaults
/ ext2 defaults
:
:
/tmp ext2 defaults
/tmp ext2 defaults
:
:
Table 3-47 Xen Hypervisor Operating
1 1
1 2
Host Channel Target
0 0
1 1
1 1
1 2
1 2
3-67.
Lun
0 0
3-117