Hitachi XP P9500 User Manual page 166

4 Check the version of HDLM.
.
Execute installux.sh or the HDLM installation utility (installhdlm)
stored on the HDLM DVD-ROM to check the version of HDLM that will be
installed.
The following example shows how to execute the command when the
mount point for the DVD-ROM is /media/cdrom:
¢
¢
A command execution example is described below. x.x.x-xx is the version
of HDLM.
KAPL09177-I HDLM version: x.x.x-xx
5 Create an installation information settings file.
.
Edit the installation information settings file based on your desired
settings. Specify any settings that are not specified in this file after
installing HDLM, as necessary.
To use the sample file, copy it from the DVD-ROM to a directory on the
hard disk. Note that the sample file name can be changed to any name.
The following shows an installation execution example for when the DVD-
ROM mount point is /media/cdrom.
# cp -p /media/cdrom/HDLM_Linux/config/sample_installhdlm.conf /
any-directory/any-file-name
For details about how to edit the installation information settings file,
which is used by the installhdlm utility, see
Information Settings File on page
6 Perform the installation.
.
Execute installux.sh or the installhdlm utility stored on the HDLM
DVD-ROM to start installation.
The following shows an installation execution example for when the DVD-
ROM mount point is /media/cdrom.
¢
3-98
The following shows an execution example for when media-volume-id
is VOL01234.
# volname /dev/cdrom
VOL01234
#
When executing installux.sh
# /media/cdrom/installux.sh -v
When executing the installhdlm utility
# /media/cdrom/HDLM_Linux/installhdlm -v
When executing installux.sh
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
Editing an Installation-
7-42.