Hitachi XP P9500 User Manual page 174

After completing the above procedure, you can perform an upgrade
installation of HDLM in a multi-path boot disk environment that uses a logical
volume (LVM2) on an HDLM device.
Settings for Using an HDLM Device as a Boot Disk
This subsection describes how to perform a new installation of HDLM in a
single-path boot disk environment that uses a SCSI device and how to set up
the environment.
Note that if the settings are incorrect, the OS might not start. For details
about what action to take if the OS cannot be started from an HDLM device,
see Countermeasures for Unsuccessful Startup of the OS from an HDLM
Device on page
The name of the boot loader configuration file used in these procedures
differs depending on the boot loader and OS. The names of the boot loader
configuration files are listed in
Configuration Files on page
GRUB
LILO
ELILO
To install HDLM in a boot disk environment that uses a SCSI device,
and set up the environment:
1 Log in to Linux as a user with root permissions.
.
2 If the OS is SUSE LINUX Enterprise Server 10 SP3 or later, specify
.
multipath=off in the boot loader configuration file.
Make sure that multipath=off has been set in the kernel line of the
boot loader configuration file. The following example shows how to specify
multipath=off:
¢
3-106
3-150.
Table 3-53 Names of Boot Loader Configuration Files
Boot loader
For Red Hat Enterprise Linux
For SUSE LINUX Enterprise Server 10 or SUSE
LINUX Enterprise Server 11
When ELILO is used as the boot loader:
:
:
image = vmlinuz-2.6.16.60-0.54.5-default
label = 51
append = "splash=silent multipath=off"
description = Linux
initrd = initrd-2.6.16.60-0.54.5-default
root = /dev/disk/by-id/scsi-35001862001472c70-part12
multipath=off is set in the underlined section.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
Table 3-53 Names of Boot Loader
3-106.
Configuration file name
/etc/grub.conf
/boot/grub/menu.lst
/etc/lilo.conf
/etc/elilo.conf