Iplink Linxl - Motorola MOSCAD 68P02958C00-B User Manual

IPLINK LINxL
## 2200 LEVEL = 0
Iplink device key
--------------------
Heap key
Network key
Network pin table : %% 3
Site ID
Link ID
IP port number
IP address
Enable RCP
Port is in Fail
Group IP address
All RTU Simulation: %% 11
Enable IPModem
Learn IP Address
Check failed sites
Max echoes to send
Max sec between echoes: %%16
Max sec to check alive: %%17
When Port is defined as MDLC Over IP (Astro, iDEN,Tetra, Terminal server or Standard Modem).
1. General Heap key for transmission and reception.
2. Network layer in the unit.
3. A pointer which allows "cabling" between two devices during run time.
4. Site ID.
5. Link ID.
6. Number of the IP Port as defined in Site Configuration.
7. IP Address as defined in Site Configuration.
8. Enable RCP- Yes or No
9. Status of Link.
10. IP address used for Group Call as defined in Site Configuration.
11. YES if the Addr. range response for 'All RTU simulation' (Network Layer Advanced Parameter) was
set to non zero.
12. YES if connected to iDEN.
13. YES if the port's IP address will be retrieved during run time, e.g. from the iDEN modem.
14. YES if the sites that are failed will be checked before transmitting to them. If the site does not reply,
transmissions will be routed to an alternative path (if such exists.) A site is considered failed when
: %% 1
: %% 2
: %% 4
: %% 5
: %% 6
: %% 7
: %% 8
: %% 9
: %% 10
: %% 12
: %% 13
: %%14
: %%15
C-88
Software Diagnostics Output