Motorola MOSCAD 68P02958C00-B User Manual page 20

MOSCAD NFM RTU MOSCAD NFM RTU
Network Network
Elements Elements
MOSCAD NFM RTU
Network
Elements
Figure 1-3: General Architecture of the MOSCAD NFM System
The MOSCAD NFM via the IP Gateway allows the system to offer SNMP (Simple Network
Management Protocol) connectivity, therefore providing a standard interface to a wide range
of NMC platforms (such as HP/OpenView, SUN/Solstice, IBM/NetView etc.).
The MOSCAD Remote Terminal Unit (RTU) represents the Element Level of the network
management model. It collects the various inputs, outputs and analog signals via a variety of
input/output (I/O) modules. In addition, the MOSCAD RTU serially interfaces to
communication devices (radio, cellular and telecommunication) and is able to emulate (speak)
their ASCII based native protocol, allowing the MOSCAD to not only monitor alarms, but to
configure and change parameters as well.
NFM Central
SNMP
TCP/IP
IP Gateway
(Proxy MIB)
MDLC Network
MOSCAD RTU
MOSCAD RTU
Network
Elements
1-5
MOSCAD
ToolBox
(over IP)
Ethernet
IP Network
Ethernet
SNMP
MOSCAD NFM RTU
Network
Elements
Network
Elements
Introduction
Ethernet
MOSCAD NFM RTU
Network
Elements