Motorola MOSCAD 68P02958C00-B User Manual page 439

Error #413: Presentation layer: in function %% format error, encryption not supported.
Encryption and compression are not supported.
May indicate system software problem. Consult product group.
Error #414: Presentation layer: in function %% format error, control number out of range.
Protocol format error.
May indicate system software problem. Consult product group.
Error #415: Presentation layer: in function %% general synchronization error.
May indicate system software problem. Consult product group.
Error #416: Presentation layer: in function %% the rx applic, buffer size is too small.
May indicate system software problem. Consult product group.
Error #417: Presentation layer: in function %% no more rooms for error buffers.
May indicate system software problem. Consult product group.
Error #450: Stock set: the stock buffer is locked for too much time
For system software developers. Consult product group.
Error #451: Stock get: the stock buffer is locked for too much time
For system software developers. Consult product group.
Error #500: IOTEST: Invalid Option: %%
Applying to a non-existing option for I/O module testing in the RTU. This may
occur when using a new version of Tool Box with new features to communicate
with an older RTU that is not familiar with those new features.
Error #501: IOTEST: Bad Device Name %% for Service %%
Problem in getting device key & pin_table out of device name.
Error #520: Minisess: illegal box nr. %% , data problem !!!
May indicate system software problem. Consult product group.
Error #540: Time_tag rack module not exist: %%
Data was received for an I/O bit that exists in an I/O module, but not defined in
the user ROM.
Error #541: Time_tag->read %%> time_tag->write %%
May indicate system software problem. Consult product group.
C-147
Error Messages