Ip Conversion Table; General; Ip Gateway Site Configuration - Motorola MOSCAD 68P02958C00-B User Manual

Toolbox version 5.50
Table of Contents

Advertisement

IP Conversion Table

General

IP (Internet Protocol) technology can be used to interface between MOSCAD RTUs and IP
Gateways over advanced radio infrastructure (e.g. digital ASTRO IP conventional systems)
and standard private IP networks. MDLC packets to be transmitted are enveloped inside IP
datagrams and sent between remote RTUs or between an IP Gateway and an RTU.
An IP Gateway can act as a gateway between the field and the SCADA Central to extract the
enveloped frames from the IP message. A Toolbox can be connected to one of the RTUs or to
one of the serial ports of the IP Gateway.
Each RTU/IP Gateway is assigned a Site ID. In addition, each RTU/IP Gateway with an IP
interface is assigned an IP address. An IP conversion table which maps Site IDs to IP
addresses is created in the Toolbox and downloaded to the RTUs and IP Gateway. This
enables routing over the IP network to the proper destination.
For more details on the possible network configurations and RTU setup, see the MDLC over
IP section of the MOSCAD Programming ToolBox Application Programmer Manual
(Advanced Features).

IP Gateway Site Configuration

Configure an IP Port as TCP/IP, as follows:
(Note that this is one of the virtual ports over Port 1, rather than physical port.)
Link ID:
(e.g. LINE 1) Same as for all RTUs.
Port number:
(e.g. 2002) Same as for all RTUs.
The rest of the parameters are set up according to normal IP Gateway procedures. Any
exceptions or known problems are described in the release notes.
5-152

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Moscad

Table of Contents