Motorola MOSCAD 68P02958C00-B User Manual page 369

Toolbox version 5.50
Table of Contents

Advertisement

## 1503
LEVEL = 3
Control channel Configuration parameters:
Wait for control - channel - access timeout Sec
Warmup control - channel time mS
Transmission timeout Sec
Wait for holdup timeout Sec
Holdup control - channel time mS
Shutup control - channel time mS
Current status of control channel : 2
Is transmission enabled : %%
1. The piggyback control channel access parameters used for its diagnostics and configuration. The
meaning of the parameters is the same as in Line, Radio or Trunk.
The piggyback control channel current status:
2. Yes - Transmitting to the control channel is enabled.
## 1504
LEVEL = 4
fskadp device - current state variables
Did plug - in modem fail test ?
Is trunk radio configured ?
Is channel monitor LED on ?
Is driver waiting for CTS at grant state ?
Is task suspended on Tx_start_1 ?
Is task suspended on Tx_start_2 ?
Is task suspended on hc11_end_of_Tx ?
Current module state
Time remaining for current state mS
Current transmitted channel
Current accessed channel
Current channel quiet time mS
Current channel busy time mS
Trunk channel status :
How long does channel not exist mS
Is transmission enabled ?
Is PTT pressed when asking for TxEn
How much time remains for PTT pressing or reset mS
Next warmup will be performed on channel
Next warmup will be performed with priority
General parameters of FSKADP (or DEVICE OCOM) module state. Notice that parameters related to
trunking are relavant if " Is trunk radio configured" is set to "Yes". :
1. Yes: Piggyback failed on first test; therefore cannot be transmitted to.
2. Yes: Radio trunk was defined in configuration.
3. Yes: LED, CM3 are on. (There is reception from one of the channels).
4. Yes: Waiting for CTS from piggyback, after completing Channel Access process, in order to begin
transmitting.
5. Yes: OCOMM module is waiting in transmission until descriptor is available (TxBD).
6. Yes: OCOMM module is waiting in transmission until current transmission is over.
(Is TxEn Active)
C-77
Software Diagnostics Output
: %% 1
: %% 1
: %% 1
: %% 1
: %% 1
: %% 1
: %% 2
- %% 1
- %% 2
- %% 3
- %% 4
- %% 5
- %% 6
- %% 7
: %% 8
: %% 9
: %% 10
: %% 11
: %% 12
: %% 13
: %% 14
: %% 15
: %% 16
: %% 17
: %% 18
: %% 19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Moscad

Table of Contents