Motorola MOSCAD 68P02958C00-B User Manual page 456

Error #1016: ABTS module, Function %%
The FLUSH function failed, but continuing
May indicate system software problem. Consult product group.
Error #1017: ABTS module, Function %%
Not enough RAM memory for Allen-Bradley load module connected to PLC !!
May indicate system software problem. Consult product group.
Error #1018: ABTS module, Function %%
Allen-Bradley to RTU PLC format translation of reply failed !!
Internal communication protocol format error. Consult product group.
Error #1100: Invalid Destination Address : %%
X25 address is too short. Can not operate call request.
X.25 address is too short.
Error #1101: Local port #%% was not found. destination Address is : %%
X25 address contains unidentified port.
Can not switch since local port is not available.
Error #1102: Invalid router 'PROVIDER' Mode: %%
Invalid mode.
Error #1103: Router table #%%, Channel #%% – status is %%
Expected status is %%, Operation code is: %%
Incorrect operation according to the states table for a single logic channel. For
example, data transfer in an unopened channel.
Error #1104: Invalid Self Address : %%
Illegal RTU X25 address.
The X.25 address defined in the configuration is not correct.
Error #1105: Router table #%% does not contain logical channel #%%
Illegal logic channel.
The logic channel does not exist. May indicate system software problem.
Consult product group.
Error #1107: Invalid Calling Address : %%
Illegal initiator's X25 address.
May indicate system software problem. Consult product group.
Error #1108: Number Of Slaves – %% is Greater Than Number of Sites – %%
The additional slaves that do not have corresponding sites are not useful.
C-164
Error Messages