Motorola MOSCAD 68P02958C00-B User Manual page 281

APPENDIX B:
Remote ToolBox Modem Setup
Factory Option Set #2 (Asynchronous Dial-up without MNP)
MODEM PARAMETERS
DCE RATE = DTE RATE
NORMAL ORIGINATE
FAST TRAIN DISABLED
AUTO RETRAIN ENABLED
TRANSMIT CLOCK INTERNAL
DIAL LINE
JACK TYPE RJ11 (PERMISSIVE)
LINE CURRENT DISCONNECT LONG ENABLED
LONG SPACE DISCONNECT ENABLED
V.22 GUARD TONE DISABLED
MNP PARAMETERS
MNP PROTOCOL DISABLED *
DTE SPEED = DCE SPEED *
FLOW CONTROL DISABLED *
XON/XOFF PASS THROUGH DISABLED
DATA COM PRESSION ENABLED *
MNP ACTIVITY TIMER OFF
MNP BREAK CONTROL 0 *
DTE PARAMETERS
ASYNC DATA
DTE RATE = 9600
8 BIT
NO PARITY
AT COMMAND SET ENABLED
IGNORES DTR
DSR FORCED HIGH
DCD FORCED HIGH
CTS FORCED HIGH
DTE FALLBACK DISABLED
OPTIONS RETAINED AT DISCONNECT
TEST PARAMETERS
BILATERAL ANALOG LOOP DISABLED
BILATERAL DIGITAL LOOP DISABLED
DTE LOCAL TEST DISABLED
DTE REMOTE TEST DISABLED
REMOTE COMMANDED TEST ENABLED
TEST TIMEOUT OFF
DIAL/DBU PARAMETERS
TONE DIAL
AUTO DIAL #1
WAIT FOR DIAL TONE
WAIT DELAY 2 SECONDS
PAUSE DELAY 2 SECONDS
CALL TIMEOUT 30 SECONDS
ANSWER ON 1 RING
B-10