Motorola MOSCAD 68P02958C00-B User Manual page 163

Downloader
stop the driver.) To change the Communication Port or Data Speed, select the parameter (left
click) and select the value from the choice list.
To specify a system software kernel file to be downloaded, select Open System File from the
File menu. The utility will default to the C:\Itbox550\system directory. You can also select
another directory. Select the desired .krl file and click on the Open button. The downloader
session will automatically be renamed System Downloader Session.
Note: The user does not need to erase the existing system software from the IP Gateway before
downloading a new system. This is done automatically by the Downloader utility.
Set the download parameters as detailed above in the Specifying system software files to be
downloaded section under Downloading Files.
Click on the Download icon or select Download this Session from the Edit menu. The
following message will appear.
Switch off the IP Gateway, and then switch it on again. This will put the IP Gateway into
bootstrap mode and enable a new system to be downloaded. The download process will begin
immediately. Upon successful completion of the download process, the DIAG LED will blink.
All the gateways LEDs will blink once and then blink again after approximately 30 seconds.
During the Download process, the ToolBox displays its current status and actions being
performed. If for any reason you need to abort the download, press the Abort icon in the
toolbar at the top of the window. During the download of the kernel file, the ToolBox displays
various statistics in the text area, as shown below.
If the version of the existing configuration or user application is incompatible with the new
version of the firmware software, an error message will appear to that effect. In this case, the
5-106