Motorola MOSCAD 68P02958C00-B User Manual page 437

Error #304: MTE: The CONTROL procedure of devices was not started, because the type of
control parameter is out of range !!
Type of requested control was :
The last valid control entry is
Internal error. May indicate system software problem. Consult product group.
Error #305: MTE: The MTE CONTROL procedure of devices failed !!!
Device Name
Control Type
Number of successive fails
The control procedure of one of the devices has failed. May indicate system
software problem. Consult product group.
Error #350: Session layer: in function %% remove slice failed. Remove slice failed.
May indicate system software problem. Consult product group.
Error #351: Session layer: in function %% get slice failed. Get slice failed.
For system software developers. Consult product group.
Error #352: Session layer: in function %% allocation of formatted buffer failed. Allocation of a
buffer failed.
May indicate system software problem. Consult product group.
Error #353: Session layer: in function %% buffer in RX is kept by lower layer.
May indicate system software problem. Consult product group.
Error #354: Session layer: in function %% no more room for error buffers.
May indicate system software problem. Consult product group.
Error #355: Session layer: in function %% received not error buffer, while in tx.
May indicate system software problem. Consult product group.
Error #356: Session layer: in function %% format error. Protocol found error.
May indicate system software problem. Consult product group.
Error #357: Session layer: in function %% unable to perform abort session.
May indicate system software problem. Consult product group.
Error #358: SESSION: In Function %% Illegal Password. Session Not Opened.
Illegal password. Session was not opened.
%%
: %%
: %%
: %%
: %%
C-145
Error Messages