Motorola MOSCAD 68P02958C00-B User Manual page 462

173 Piggyback got from 68302 frame error
174 Piggyback got from 68302 noise error
175 Piggyback Config register not programmed properly
Error #1553: Failed configuring or diagnosing INTRAC modem (ID = %%)
The error message ID (%%) may be one of the following:
ID Description
100 RTU received irrelevant config/diagnostics ACK from piggyback
101 RTU received irrelevant config/diagnostics ACK from piggyback
102 Piggyback failed to write parameters to its internal eeprom
103 RTU did not receive answer about config/diagnostics from piggyback
Error #1555: Cannot operate repetition, Heap is empty
Heavy transmission traffic not necessarily on the INTRAC/MEIC only, but
because the heap serves the other MDLC channels.
Error #1557: INTRAC system table: invalid station address (StnAdr) %%
Invalid StnAdr value in the INTRAC system tables (database builder).
Possible range: 0-8191
Error #1563: INTRAC system table: invalid repeater mode (RptMod) %%
Invalid RptMod value in the INTRAC system tables (database builder).
Possible range: 0-1
Error #1564: Transmission failed: %% channel at INTRAC/MEIC port (ID = %%)
The first variable in this message is the channel name. The second (ID) may be
one of the following:
The error message ID (%%) may be one of the following:
ID Description
0 0comm module failed physical_transmit()
1 0comm module failed physical_wait(EOTX)
10 Fskadp could not transmit because CTS signal is stuck. It means that the
piggyback internal buffer is full.
11 Fskadp could not transmit because the channel was busy
12 UART transmission timeout occurred at Fskadp module
13 'Wait for Holdup' transmission timeout occurred af Fskadp
14 fskadp_warmup() was called with illegal piggyback
Error #1601: Could not identify INTRAC Modem piggyback
Problem with identifying the modem board. Possible hardware problem.
C-170
Error Messages