Motorola MOSCAD 68P02958C00-B User Manual page 435

Error #282: Unoperational Communication CHANNEL on: PORT #%% CONTROL=%%
STATUS=%%
The port is transferred to software mode. This message is displayed if CD is not
active.
Error #283: Unoperational CHANNEL Internal LOOP on: PORT #%% CONTROL=%%
STATUS=%%
Incompatibility between the frame that was sent and received by the internal
loop.
Error #284: Unoperational CHANNEL External LOOP on: PORT #%% CONTROL=%%
STATUS=%%
Incompatibility between the frame that was sent and received by the external
loop.
Error #285: Unsuccessful CHANNEL Configuration on: PORT #%% COMMAND=%%
ANSWER=%%
Internal modem does not exist or illegal parameters were downloaded.
Error #286: Uncontrollable CHANNEL Configuration on: PORT #%% COMMAND=%%
DATA=%%
Problem in the internal modem.
Error #287: No response from internal DPSK modem on: port #%% command=%%
data=%%
Problem in the internal modem-piggyback plug in Port Type unit for Port 3.
Error #288: An Incompatible piggyback was found.
The configuration was defined for Radio model: R%%
The installed piggyback ID is: %%
(see the table below for conversion)
The following table lists the available IDs:
Piggyback ID
1
2
3
4
Other
For Spread Spectrum radio only (MOSCAD-L only).
Error #289: Could not program the spread spectrum (aironet) radio successfully. The
readback registers value was different from the written ones.
Piggyback cannot be programmed. Switch or fix piggyback.
Description
Spread Spectrum (Aironet) R202
Spread Spectrum (Aironet) R100
Spread Spectrum (Aironet) R202 AND DPSK interface
Spread Spectrum (Aironet) R100 AND DPSK interface
Unknown, invalid or no piggiback
C-143
Error Messages