Motorola MOSCAD 68P02958C00-B User Manual page 161

Don't Erase Flash Before Download
The download operation does not erase the contents of the flash memory.
Erase All Flash Before Download
Causes the utility to erase the contents of the flash memory before the download.
Erase Flash and Preserve SiteConf
Causes the utility to erase the contents of the flash memory, except for the site configuration
data, before the download.
Unit Reset
Specify whether the IP Gateway should be reset after downloading or under what
circumstances the IP Gateway should be reset. The only possible values is:
Reset after total download
If you have changed the site ID, you must first download the site configuration alone, with the
modified ID. If you want to download more data, repeat the Download operation for the
additional blocks (do not download the site configuration together with the other blocks).
Log File
Specifies the name of the file where the download session is logged.
New Site ID
Enables the user to change the Site ID of the IP Gateway. The Site ID defines the unit's
logical address, and it may range from 1 to 65,287. By default, this value is 1. This parameter
is only visible when adding a site configuration file to the session. If the site configuration file
is deleted from the session, this parameter will also be deleted.
System Address
The system address is the physical base address assigned to the whole system, and may range
from 1 to 65,287. The base address is used in broadcast transmissions. By default, this value
is 0. This parameter is only visible when downloading the site configuration. If the site
configuration file is deleted from the session, this parameter will also be deleted.
Files
Specify the files to be downloaded to the IP Gateway. The files can include Site Configuration
(.cfg), Network Configuration (.scf), Phone Book (.tel), Sites Table (.stb), SNMP
Configuration (.snm), Host Table (.hst), IP Conversion Table (.ipc), DataTac (RNC) Modem
ID Table (.rnc), NTP Configuration (.ntp). A new version of the system software (.krl) can also
be downloaded in a separate System Download session.
Specifying files to be downloaded:
First choose a file type for the file to be downloaded from the File Type choice list at the
bottom of the Directory bar.
Find the desired file name on the computer, using the Drive parameters described below.
Drag the file name to the session text area or right-click on the file and select Add to the
5-104
Downloader