Iplink Linxl - Motorola MOSCAD 68P02958C00-B User Manual

## 2398
PPP is not created on this port
User has tried issue level 1 or 2 for SLIP port (## 2301 or ## 2302). Port is not PPP.
## 2399
PPP was not initialized yet try again later
User has tried issue level 1 or 2 for PPP port (## 2301 or ## 2302). Port is still initializing and cannot
provide data. Try again later.
IPLINK LINxL
## 2500 LEVEL = 100
RCP user parameters
--------------------
Radio IP address
RCP IP port
RTU sets radio in encrypted mode
Time to wait while diagnosing radio [millisec] : %%4
1. IP address of radio.
2. Should always be 469.
3. If radio is encrypted, this parameter will be Yes. If radio is in clear, this parameter will be No.
4. Radio diagnose reply timeout, as defined in Site Configuration.
## 2501 LEVEL = 101
Status of RCP
--------------
Is radio being configured
Has configuration of radio failed
RCP request of which configuration failed
Last request SDU tag number
Last request sent to radio
Is radio registered in infrastructure
Is data service not available
Is ICMP:Network unreachble received
Has radio failed transmission due to encryption problem : %%9
Last report received from radio
Is port in 'Fail' mode
1. If RTU is configuring radio (radio startup, RTU startup or when making connection), this will be yes.
In this case, the data will remain pending until it can be transmitted.
2. Whether the configuration of the radio has failed. If so, data cannot be transmitted by way of the
link/radio.
3. Describes which configuration message failed.
: %%1
: %%2
: %%3
C-101
Software Diagnostics Output
: %%1
: %%2
: %%3
: %%4
: %%5
: %%6
: %%7
: %%8
: %%10
: %%11