Codabar Fixed Length 2 - Datalogic Magellan 9500 Product Reference Manual

Codabar Fixed Length 2

NOTE
6-246
This feature specifies Codabar second fixed length.
Length in this case includes start, stop or check and data characters, but
does not include full ASCII shift characters.
This feature applies when Codabar Length Control is set to fixed-length
decoding.
Decodable length is four when the optional check character is present.
If Fixed Length 2 is set to 00 (zero), then Fixed Length 1 will apply.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code,
need to cover any unused bar codes on this and the facing page to
ensure that the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C that rep-
resent the desired fixed label length. The selectable range for this
option is 00, or 03 to 50. Pad all single digit numbers with a leading
zero to yield a two-digit entry (03-50).
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET CODABAR FIXED LENGTH 2
SET CODABAR FIXED LENGTH 2
below. You'll
®
Magellan 9500