Code 93 Minimum Label Length - Datalogic Magellan 9500 Product Reference Manual

Code 93 Minimum Label Length

NOTE
Product Reference Guide
This feature specifies the minimum allowable length of a Code 93 label.
Length in this case includes data characters, but does not include start, stop,
full ASCII shift, or check characters. This feature applies when Code 93
Length Control is set to variable-length decoding.
Minimum label length should be less than or equal to maximum label length.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code,
below. You'll need to cover any unused bar codes on this and the fac-
ing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C that rep-
resent the desired minimum label length. The selectable range for
this option is 01 to 50. Pad all single digit numbers with a leading
zero to yield a two-digit entry (01-50).
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET CODE 93 MINIMUM LABEL LENGTH
SET CODE 93 MINIMUM LABEL LENGTH
Code 93 Enable
6-253