Upc-E Label Id - Datalogic Magellan 9500 Product Reference Manual

UPC-E Label ID

NOTE
Product Reference Guide
This feature specifies a UPC-E label ID to be added to bar code data.
The programming feature, RS-232 Label ID Control, designates whether the
Label ID is transmitted as a prefix or suffix or if Label ID is disabled.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code,
cover any unused bar codes on this and the facing page to ensure the
scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C that rep-
resent the desired Label ID characters; entered as two hex pairs. A
table containing the
Hex Values is available in the inside back cover of this manual.
ASCII parameters must be input by scanning a pair of hexadecimal
digits for each character. Thus, to set a two-character value of AB,
bar codes containing the digits '4', '1', '4', and '2' must be scanned.
The selectable range for this option is any hex value from 00 to FF.
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET UPC-E LABEL ID
ASCII Character Set
SET UPC-E LABEL ID
UPC-E Enable
below. You'll need to
and their corresponding
6-135