Datalogic Magellan 9500 Product Reference Manual page 93

Power-up
Scanner power-up is signified by any or
all of the following:
- Facet wheel shows movement
- Lasers turn on
- Status LED(s) turn on
- Speaker sounds tone(s)
- Remote display shows message
- A single red dot is visible on the 7-
segment display
Flashing Green LED
If the Green LED is flashing slowly, the
scanner is most likely in Sleep Mode.
Press and release the Volume/Tone
Push Button or wave your hand in front
of the vertical window to "wake-up" the
scanner.
A flashing Green LED can also mean
the scanner has been disabled by the
POS terminal. To exit this mode, cycle
power or have the terminal re-enable
the scanner.
Selftest Failure
If the scanner fails its Selftest, the
following takes place:
- Speaker sounds a tone at the lowest
value for approx. 3 seconds.
- Green and Yellow LEDs flash on and
off alternately.
- 7-segment display shows a code (1 to
C) to indicate the failure.
Consult the Selftest flowchart if you're
unsure the unit has passed Selftest.
Will the
scanner read
bar codes
reliably
?
NO
Go to Poor/No
Reading flowchart
Product Reference Guide
Figure 4-2. Problem Isolation: Start
START
Does
the scanner
power-up
YES
Is the
Green LED
Lit
YES
Does
the scanner
pass Selftest
YES
Does the
YES YES
EAS Antenna
deactivate
tags
?
NO
Go to EAS System
flowchart
For units using an AC/DC adapter, verify that...
1. AC power cord is connected to a functional AC outlet.
2. IEC connectors are firmly connected.
3. DC power cord is firmly connected to scanner.
If your unit is a model which receives Power Off the
Terminal POT), verify that the I/F cable is securely
connected at both ends.
Power
Supply
NO
Have you
NO
checked the
power
connections
?
?
Ensure the Green LED is
NO
enabled via pro-
gramming bar codes.
?
NO
Go to Selftest
flowchart
?
Does the
YES
scale weigh
correctly
?
NO
Go to Scale
flowchart
Flowcharts
Magellan
Check these
potential problems:
YES
- AC power cord
- AC/DC adaptor
- AC outlet
Is the
Green LED
Lit
?
YES
Call Tech Support
Other Problems?
Call Tech Support
NO
4-7